Stop Fighting Your Glassware Furnace
Let’s be honest: standard infrared lamps are great until they aren’t. The second you try to use them in a cramped furnace or with a piece of glass that isn’t a perfect cylinder, things go south. You end up with “dead zones” where the glass stays cold, or worst-case scenario, hot spots that crack your work. It’s frustrating. We fix this by just building the lamps to fit your actual setup, not some generic factory standard. Dealing with tight spaces If your footprint is tiny, you can’t just shove a bulky housing in there and hope for the best. We build our lamps down to the millimeter. By tweaking the length and the curve of the quartz tube, we make sure the heat hits the glass at the exact distance it needs to. No more guessing. No more “close enough.” You get steady heat across the whole piece without having to tear apart your furnace chassis and start over. Getting the power right Size is only half the battle. It’s really about where the heat goes. If you go with a shorter, high-wattage lamp, you get a lot more heat density. That means your ramp-up times during annealing get a lot faster. But here is the catch: you have to make sure your wiring and power supply can actually handle that load. And if you’re pushing for extreme wattage in a tiny tube, you’ll need the right cooling fans, or you’ll burn out the ends of the lamp. Making it actually fit We can shape these heaters to wrap around your product or slide into those narrow channels that usually drive you crazy. This means you can ditch those clunky reflectors that take up way too much room. The best part? They wire right into the controllers you already have. Since we match your physical dimensions, these are basically drop-in replacements for those old, dying elements. You get better coverage and a better result without having to move a single bolt on your machine.