Ceramic lamp holder SK15

Fri, 17 Jul 2026 02:49:36 +0800

Dealing with Cold Spots in Glass Annealing

If you’re working with glassware that has a lot of weird curves or complex shapes, you know the headache of “dead zones.” You set your kiln, everything looks right on paper, but you still end up with cold spots. Then, the glass stresses out and cracks. It’s frustrating, and it’s a waste of material. The problem is usually that standard heating elements just can’t “reach” every angle. To fix this, we’ve started using infrared heating lamps held in place by SK15 ceramic holders. Why the ceramic matters Here is the thing: you can’t just use plastic or cheap composites for this. The heat in an annealing cycle is brutal. Plastic will just melt or burn out. That’s why we stick with SK15 ceramic. It takes the heat without warping. This is a big deal because if a lamp shifts even a tiny bit, your focal point is gone. Suddenly, you’ve just created a brand new cold spot. Getting the coverage right To actually hit those tight curves, you need a lot of heat coming from different directions. We do this by wiring shortwave IR lamps in a staggered layout, basically wrapping the heat around the piece. The SK15 connectors keep the electrical contact solid, even when the temperature is jumping up and down. You can tweak the wattage based on how thick your glass is. More wattage means more heat, but be careful. If you put the lamps too close to the glass, you’ll get “hot spots” that can ruin the piece. It’s all a balancing act between where the lamps sit and how fast your conveyor is moving. Making it work on your floor If you’re still using old heating ribbons, swapping them for these SK15-mounted lamps is a breath of fresh air. They take up way less space and they react much faster. It’s a pretty easy swap for most old systems. Just a quick heads-up: check your wiring. A full array of these lamps pulls a lot of current. You don’t want to be the person tripping the breakers right in the middle of a production run.

Ceramic heater (PTC)

Sun, 17 May 2026 18:32:51 +0800

Introduction

Here’s the thing about industrial heating: you can’t afford to gamble. You need heat that shows up, right on time, and doesn’t quit. That’s exactly why we build these PTC ceramic heaters. They’re made for the real world—the kind of environment where you need heat fast, predictable, and rock-solid. No drama, no burnouts. Just a compact powerhouse that gets the job done, day after day.

The Power Behind the Heat

We spec these heaters to run at high voltage—think 400V—because you need serious wattage packed into a small space. A common setup is a 300mm tube pushing 2500W. That gives you a high watt-density profile, which basically means it heats up fast. Really fast. And it’s designed to slip right into your machinery. So you get that quick ramp-up and steady temperature control without having to blow up your electrical footprint.

Ceramic on Quartz Heater Technology Core

Ceramic lamp holder SK15

Dealing with Cold Spots in Glass Annealing

Ceramic heater (PTC)

Introduction

The Power Behind the Heat