We build industrial electric heaters around a high-voltage halogen quartz tube—because when you need intense heat in a tight spot, there’s no room for compromise. Here’s the thing: it runs on400V, not 230V. That choice matters. It lets you pack serious wattage into a small footprint without overloading your wiring. So a 2500W load stays manageable on the line, and the 300mm length focuses the heat right where you need it. If your machine has tight clearances, this heater slips in cleanly—no bulky housing, no fuss. The quartz tube is the unsung hero. It handles wild temperature swings without cracking under thermal shock. Inside, the halogen cycle keeps the filament steady, so output stays consistent shift after shift. And the**R7s base?**Practical, solid. It locks in securely, carries the load without drama, and drops straight into standard lampholders. This setup is made for industrial work that demands fast, focused heat—plastic process heating, component drying, localized thermal testing. But yes, there’s a trade-off: 2500W in a small package throws off real heat. Plan on proper cooling and shielding around the install point. We built this for repeatability. Wire it up, set the distance, and it delivers the same heat profile again and again. No surprises. Just steady, reliable performance.